Motorola and V.32bis - Manual (Page 158)

A-36 Configuration Quick Reference
Configur
ation
Q
uick-Ref
e
re
nce
ACCESS
SECURITY Group PW Determines if the modem can verify a received password when PW Verify=Mngr (AT * ZV) and
the network management system is unable to perform the verification. This option is not accessi-
ble from the front panel or the AT ACU. It is displayed for status purposes only.
=Disable The modem cannot verify the password.
:Enable The modem can verify the password using its Group PW stored internally.
NETWK
CNTL OPT’S OverrideMode Determines whether your modem can be controlled by the network manager.
=Off The network manager can attach your modem. When it has attached, front panel control is
locked out. You can display options and status in the front panel menu tree, but you cannot
change options. If you attempt to change a setting, the modem displays Net Man Attached.
:On The network manager cannot attach your modem.
NC Address Lets you set the modem’s network control address. This is the address that modems use with the
SET RMT LL ADDR and SRCH RMT LL ADDR functions. The range of addresses is 0 to 254.
To set a network control address, see “Performing Numeric Entry” in this appendix.
NC PortRate Set the NC Port Rate option to match the speed of your network manager. This option controls
the speed of the NC ports on your modem’s rear panel.
= 75 Configures the network control port for speeds indicated in bits per second (bps).
: 110
: 150
:1200
:2400
:4800
:9600
Pass Thru The modem uses an in-band secondary channel to pass network management data to the remote
modem. The channel is not disruptive to main channel user data. Pass Thru controls how
network control data is passed to the remote modem when the modem is configured as DIAL
.
=opt 1 The local modem (connected to a network manager through the NC port) does not forward all
network management data received from the NC port to the remote modem over the in-band sec-
ondary channel. Only commands from the network manager to the remote modem are passed
through. Only remote-modem responses are passed to the network manager.
=opt 2 The modems do no filtering. They pass all network management data received from the NC port
to the in-band secondary channel and from the in-band secondary channel to the NC port.
SET RMT LL
ADDR New Address=nnn
Rmt Ser#=
nnnnnnn
Rmt Nest
Modem=No, A, B.
The SET RMT LL ADDR menu is for use with remote configuration on leased lines. Using this
option, you can set the remote modem’s address.
SRCH RMT
LL ADDR Rmt
Ser#=nnnnnnn
Rmt Nest
Modem=No, A, B.
The SRCH RMT LL ADDR menu is for use with remote configuration on leased lines. Using
this option, you can search for the remote modem’s address.
Table A-2.
Front Panel Configuration Options (Continued)
326X Menu
Parameter &
Option
Description
Gray shading indicates country-specific options. See Appendix C for your country’s options.