Motorola and V.32bis - Manual (Page 43)

Installing the Modem 2-9
Installing
the Modem
Installing a Ferrite Cylinder on a Power Cable
Do the following for each power cable of a Modulus enclosure populated with 3267
and 3268 V.34 Modems.
1) Snugly wrap the cable once completely around the cylinder (Figure 2-6).
2) Set the cable into the cylinder cutouts.
3) Ensure that 1 to 1-1/2 inches of the cable protrude from the cylinder (on the
end you insert into the backplane connector).
4) Snap the cylinder closed. You can reopen and close it to reset the cable.
5) Insert the cable into the Modulus enclosure connector (with the ferrite cylinder
close to the connector).
Figure 2-6. Installing a Ferrite Cylinder on a Power Cable
Cable Looped Once
Around Cylinder
Ferrite Cylinder
Cutout
Power Cable
1
2
1 1"- / "
To Modulus Enclosure Connector
To Power Jack