Motorola and V.32bis - Manual (Page 67)

Configuring the Modem 4-5
Confi
guring
the Modem
326X FAST V.34 and 326X FAST -SDC Notes
The information in this section applies when operating at the higher DTE rates
available with the 326XFAST V.34 and 326XFAST-SDC Series Modems.
• If the communications software package supports the higher terminal rates
available with these modems, and you want to use the package’s auto dial or
auto answer features, set the modem’s DTE Rate (TERMINAL OPT’S
category) to that of the package.
• Some communications packages do not let you select the higher rates available
with the 326XFAST V.34 modem while using the package’s auto dial or auto
answer functions. To take advantage of the higher DTE rates, do the following:
a) Set the package for Direct or Terminal mode.
b) Select the higher speed of the package.
c) Set the modem’s DTE Rate to match the package’s set speed.
d) Use the AT command set to establish the connection.
• Some file transfer protocols offered by a communications package may not
operate properly when DTE Rate is greater than 38.4 kbps, because some
serial ports cannot sustain data transmission at these rates.
If the Communications Software and Modem Do Not
Operate...
If, after following the suggestions in this section, you cannot get the communications
software package and modem to operate, refer to Chapter 6, Troubleshooting Guide.
If you still cannot get the communications software package and modem to operate,
contact your software vendor for assistance.
Preparing for Operation
The procedures in this chapter assume that you are installing the modem for the first
time. If you want to reinstall the modem, perform the procedure(s) below to
reinitialize the modem’s memory. NOTE: Reinitializing modem memory sets
modem parameter options back to factory defaults (Option Set 1) and deletes stored
telephone numbers from memory.
Reinitializing Memory from the Front Panel
1) Press twice. Press until the modem displays Reinit Memory.
2) Press . The modem displays Reinit Mem?
3) Press to reinitialize modem memory.
Reinitializing Memory Using the AT&F Command
You can also reinitialize memory by entering AT&F<CR> from the terminal.