Motorola and V.32bis - Manual (Page 91)

Configuring the Modem 4-29
Confi
guring
the Modem
Remote Access Reset
Remote access reset enables someone unfamiliar with the AT command set to
quickly configure a local modem so that another modem can dial into it. Then you
can use the remote modem to configure local modem options. Remote access reset
configures the modem to:
• Answer an incoming call
• Accept a network management session
• Accept a remote configuration session initiated by the calling modem
• Disconnect a call if one is in progress
• End any test in progress
Operation
To select remote access reset, press and simultaneously for three seconds. Rmt
Access Reset displays. The modem resets itself to settings that let it answer a call
and be accessed by an NMS or remote modem. The modem may be dialed into and
reconfigured. Stored phone numbers and saved option sets remain unchanged.
When Remote Access Reset Is Disabled
Remote access reset is not supported when the modem is attached to a network
management system. If you select it in this situation, NETMAN ATTACHED!
displays. To invoke remote access reset, set OverrideMode=On (NETWK CRTL
OPT’S).
Remote access reset is not supported when the modem is password protected
(i.e., when pressing
and for three seconds displays PASSWD
PROTECTED). To choose the remote access feature, you must first unlock the
modem, either from the front panel, or with the AT
* PN (enter password)
command.