Motorola Communications Gateway - Manual (Page 53)

48 Communications Gateway User Guide
Replacing the Battery, continued
Introduction Before You Begin Installation & Configuration FAQ Troubleshooting Glossary License
X
Home Print Exit
10 On a slight angle, gently slide the top-right corner of the battery under the battery
hook as shown at left.
While you rotate the battery into position, to avoid pinching the wires between the
battery and the base, be sure the battery wires are not under the battery. Pinching
the wires between the battery and the base:
■ May damage the wires
■ Will cause the battery to seat incorrectly
11 Rotate the battery into position under the battery snaps as shown by the arrow at left.
When the battery is fully seated, the snaps engage the battery base.
12 Carefully replace the battery compartment cover. Do not force the cover closed. If
the battery compartment cover does not close easily, check that:
■ The power cord is positioned correctly in its opening
■ The battery is correctly seated (you performed steps 14 to 15 correctly)
Then rotate the battery
under the snaps
First, slide the battery
under the hook