Millennium Enterprises Net Safety MLP-A/AR - Manual (Page 14)

Net Safety Monitoring Inc
MLP-A/AR/AD-ST1400-25 9
R EMOTE R ESET
The Millennium can be set for remote reset. A normally open Push Button
Switch must be connected between the RST and the COM terminals on the
Terminal Board and the Relay Option Latch Status must be set to
Latching .
Figure 10: Remote Reset
MODBUS T ERMINATION
Devices are networked in a daisy chain. The device located at the end of the
chain requires end of line termination. Place both jumpers over the pins, as
shown in Figure 11, "Modbus Termination Jumpers", on page 9, for end of line
termination.
Figure 11: Modbus Termination Jumpers
RST
+24V
COM
4-20
ISO
Terminal Board
PowerTerminal Strip