Motorola Netopia 3397GP - Manual (Page 198)

Administrator’s Handbook
198
Packet Filtering Settings
Packet Filtering has two par ts:
◆
Create/Edit/Delete Filter Sets, create/edit/delete rules to a Filter Set.
◆
Associate a created Filter Set with a WAN or LAN inter face
set security pkt-filter filterset filterset-name [ input_filter | output_filter ] index
forward [ on | off ]
Creates or edits a filter rule, specifying whether packets will be for warded or not.
☛
NOTE:
If this is the first rule, it will create the filter-set called filterset-name, other wise it will edit
the filterset.
If the index is not consecutive, the system will select the next consecutive index. If the
index does not exist, a rule will be created. If a rule exists, the rule will be edited.
set security pkt-filter filterset filterset-name [ input_filter | output_filter ] index
idle-reset [ on | off ]
Turns idle reset on or off for the specified filter rule. A match on this rule resets idle-timeout status and
keeps the WAN connection alive. The default is
off. For idle-reset to be displayed, forward must be
enabled on a filter rule.
set security pkt-filter filterset filterset-name [ input_filter | output_filter ] index
frc-rte [ on | off ]
Turns forced routing on or off for the specified filter rule. A match on this rule will force a route for pack-
ets. The default is
off. For frc-rte to be displayed, forward must be enabled on a filter rule.
set security pkt-filter filterset filterset-name [ input_filter | output_filter ] index
gateway ip_addr
Specifies the gateway IP address for forced routed packets, if forced routing is enabled.
set security pkt-filter filterset filterset-name [ input_filter | output_filter ] index
src-ip ip_addr
Specifies the source IP address to match packets (where the packet was sent from).
set security pkt-filter filterset filterset-name [ input_filter | output_filter ] index
src-mask mask
Specifies the source IP mask to match packets (where the packet was sent from).