Motorola Netopia 3397GP - Manual (Page 203)

203
set system ftp-server option [ off | on ]
Enables or disables a simple FTP ser ver in the Gateway. If enabled, the Gateway will accept binar y
embedded software images (‘.bin’) files or command line configuration files.
set system log-size [ 10240... 65536 ]
Specifies a size for the system log. The most recent entries are posted to the beginning of the log.
When the log becomes full, the oldest entries are dropped. The default is 30000.
set system persistent-log [ off | on ]
When set to on, causes the log information to be kept in flash memory.
set system idle-timeout { telnet [ 1...120 ] | http [ 1... 120 ] }
Specifies a timeout period of inactivity for telnet or HTTP access to the Gateway, after which a user
must re-login to the Gateway. Defaults are 5 minutes for HTTP and 15 minutes for telnet.
set system username { administrator name | user name }
Specifies the usernames for the administrative user – the default is admin; and a non-administrative
user – the default is user.
set system password { admin | user }
Specifies the administrator or user password for a Motorola Netopia® Gateway. When you enter the
set system password command, you are prompted to enter the old password (if any) and new
password. You are prompted to repeat the new password to verify that you entered it correctly the first
time. To prevent anyone from obser ving the password you enter, characters in the old and new pass-
words are not displayed as you type them. For security, you cannot use the “step” method to set the
system password.
A password can be as many as 32 characters. Passwords are case-sensitive.
Passwords go into effect immediately. You do not have to restar t the Motorola Netopia® Gateway for
the password to take effect. Assigning an administrator or user password to a Motorola Netopia® Gate-
way does not affect communications through the device.
Supported FTP commands
MODE (data transfer mode (only Streaming supported)
NOOP (send back ok)
PORT (specify client address:port for data)
QUIT (quit)
STOR (send file to FTP server)
SYST (get system info about FTP server)
TYPE (set data representation type, ASCII and IMAGE (BIN) only supported)
USER (send username for authentication)