Installation & operating instructions – Majestic Appliances 360DVS3 User Manual

Page 3

Advertising
background image

3

360DVS Series Direct Vent Fireplaces

10006326

This gas appliance should be installed by a qualified installer,
preferably NFI or WETT (Canada) certified, in accordance
with local building codes and current CSA-B149.1 Installation
Codes for Gas Burning Appliances and Equipment. If the unit
is being installed in a mobile home, the installation should comply
with the current CAN/CSA Z 240.4 code. For U.S.A. Installations,
follow local codes and/or the current National Fuel Gas Code,
ANSI Z223.1/NFPA 54.
FOR SAFE INSTALLATION AND OPERATION PLEASE
NOTE THE FOLLOWING:
1. This fireplace gives off high temperatures and should be located

out of high traffic areas and away from furniture and draperies.

2. Children and adults should be alerted to the hazards of high

surface temperatures of this fireplace and should stay away
to avoid burns or ignition of clothing.

3. CAUTION: Due to high glass surface temperature, chil-

dren should be carefully supervised when in the same
room as fireplace.

Installation & Operating Instructions

This appliance may be installed in an aftermarket, per-

manently located, manufactured home, or mobile home

where not prohibited by local codes.
This appliance is only for use with type of gas

indicated on the rating plate. This appliance is not con-

vertible for use with other gases, unless a certified kit is

used.

Proposition 65 Warning: Fuels used in gas, wood-
burning or oil fired appliances, and the products of
combustion of such fuels, contain chemicals known to
the State of California to cause cancer, birth defects
and other reproductive harm.
California Health & Safety Code Sec. 25249.6

IMPORTANT:

PLEASE REVIEW THE FOLLOWING CAREFULLY

Remove any plastic from trim parts before turning the
fireplace ON.
It is normal for fireplaces fabricated of steel to give off
some expansion and/or contraction noises during the
start up or cool down cycle. Similar noises are found with
your furnace heat exchanger or car engine.
It is not unusual for your gas fireplace to give off some
odor the first time it is burned. This is due to the curing of
the paint and any undetected oil from the manufacturing
process.
Please ensure that your room is well ventilated - open
all windows.
It is recommended that you burn your fireplace for at least
ten (10) hours the first time you use it. If the optional fan
kit has been installed, place the fan switch in the “OFF”
position during this time.

11. When the fireplace is installed directly on carpeting, vinyl

tile, or any combustible material other than wood, it must be
installed on a metal or wood panel extending the full width
and depth of the fireplace.

12. This fireplace requires adequate ventilation and combustion

air to operate properly.

13. This fireplace must not be connected to a chimney flue serving a

separate solid fuel-burning fireplace.

14. When the fireplace is not in use, it is recommended the gas

valve be left in the “OFF” position.

WARNING: Check with your electronics manufacturer
before installing a television or other electronic de-
vice above this fireplace.

360DVS2/ 360DVS3/ 360DVSL/ 360DVSR

CERTIFIED TO

ANSI Z21.88-2005 / CSA 2.33-2005

Vented Gas Fireplace Heaters

�������

��������������

������������

������������������

�������������

��������������������

���������������

4. Under no circumstances should this fireplace be modified.

Parts removed for servicing should be replaced prior to
operating this fireplace again.

5. Installation and any repairs to this fireplace must be per-

formed by a qualified installer, service agency or gas sup-
plier. A professional service person should be contacted to
inspect this fireplace annually. Make it a practice to have
all of your gas fireplaces checked annually. More frequent
cleaning may be required due to excess lint and dust from
carpeting, bedding material, etc.

6. Control compartments, burners and air passages in this fire-

place should be kept clean and free of dust and lint. Make
sure the gas valve and pilot light are turned off before you
attempt to clean this fireplace.

7. The venting system (chimney) of this fireplace should be

checked at least once a year, and if needed, your venting
system should be cleaned.

8. Keep the area around your fireplace clear of combustible

materials, gasoline and other flammable vapor and liquids.
This fireplace should not be used as a drying rack for cloth-
ing, nor should Christmas stockings or decorations be hung
on or around the fireplace.

9. Under no circumstances should any solid fuels (wood, coal,

paper or cardboard, etc.) be used in this fireplace.

10. The flow of combustion and ventilation air must not be ob-

structed in any way.

Advertising
This manual is related to the following products: