MITSUBISHI ELECTRIC WT03939X20 - Manual (Page 100)

99
[Interlock operation error: Error report output]
When the interlock control with the M-NET device is failed (when no response to the interlock
operation command is received from the M-NET device), Whether to output or doesn't output the error
report can be set for each output channel.
* The pressed (sunken) button shows the currently “Output” status.
(6) Select the line to be set, and click [Edit].
To copy the preset interlock setting, select
the line to be copied, and click [Copy], then
select the line to be pasted, and click [Paste].
To delete the setting, select the line to be
deleted, and click [Delete].
(7) DIDO controller (66DC) Interlock control setting
screen will appear.
[Interlock No.]
The pattern No. of interlock control setting is
shown.
[Ch No.]
Set the input Ch No. of interlock source.
[Interlock operation conditions]
Set the interlock condition (operation, stop,
error occurrence, error reset) of the input
channel (Ch No.) of the interlock source.
[Interlock target]
Select the unit address to be controlled.
When the contact on the DIDO Controller is output, select the address of the DIDO Controller.
Ch1
Ch2
Ch3
Interlock operation error: Error report output setting
Output channel
Error report
DIDO
Controller
(66DC) Interlock
Operation
Comman
M-NET Output
Output
No response
x
* * *
Indoor unit