MITSUBISHI ELECTRIC WT03939X20 - Manual (Page 19)

18
1.4.3 Starting the On-Line Monitor(G-50A connection)
* To use the Maintenance Tool via G-50A (Network), license registration for the G-50A to be used is
necessary.
Purchasing the license No. for each G-50A to be used, conduct the license registration through the Web
browser (http://[IP address of the G-50A]/ administrator.html). After selecting "Maintenance Tool" of the
optional function on the Web Browser Screen displayed, enter the purchased license No..
For the detail of the license registration, see Chapter 4 [Registering a License for Optional Functions] of
Central Controller Model: G-50A Web Browser Operation Manual (For manager).
* To use the Maintenance Tool via G-50A (Only for LAN mode and Dialup connection mode), please check a
setup of Internet Connection Firewall of PC. If the FIREWALL function is used, communication will be normally
impossible with G-50A, and normal data will not be displayed.
For detail, please refer to [6. How to change setting of Firewall].
In the case of permanently installing an anti-virus software and always started under this environment, the fire
wall function of this software may be activated sometimes. In such case, The normal communication with
G-50A will be hindered not displaying data normally. When operating Maintenance Tool, finish the anti-virus
software once or remove the fire wall function.
1.4.3.1 In case for local connection
In the case when on line monitoring is applied to air conditioning system via G-50A by connecting the
Maintenance Tool to LAN locally.
(1) Clicking "G-50A(Network)" on the selection screen of
Monitor mode selects "Local connection" simultaneously.
Last click " ."
(2) Next IP address input screen is displayed. Here,input IP
address of G-50A connected to the air conditioning system
of which operating information is desired to monitor, and
click on .
NOTE:
•
It is required to set to the IP address in the same system with G-50A to be connected to Maintenance Tool PC
from [Control Panel].