MITSUBISHI ELECTRIC WT03939X20 - Manual (Page 84)

83
The following settings and monitoring can be made on AI Controllers (PAC-YG63MCA).
When G(B)-50A or TG-2000A is connected, the setting must be made on G(B)-50A Web Browser or
TG-2000A.
(a) Settings
*Current time
*Measurement category (temperature, humidity)
*Measurement range (upper limit, lower limit, correction value)
*Out-of limit alarm value (alarm threshold, alarm-off threshold)
(b) Monitoring
*Current measurement value
*Current out-of-limit alarm status
*Correction value for Pt100 detection
*Dip switch setting
*Measurement value history
*History of out-of-limit alarm/alarm-off
*Change history of measurement category (temperature or humidity)
3.13.2.1 Monitoring measurement value on AI Controllers (63MC)
(1) Click [Option] in the menu bar and
select [DIDO/AI/PI] -> [AI/PI setting] in
the sub-menu.
(2) Click of the unit (AI Controller)
to be set or monitored on the Main screen.
(3) The current measurement value is monitored, and
AI controller (63MC) measurement value
monitoring screen will appear.
[Measurement value]
The current measurement value of
each channel is shown.
[Alarm status]
The current out-of-limit alarm status is shown.
[Upper detection] [Upper cancellation]
[Lower detection] [Lower cancellation]
The preset alarm detection value and
alarm cancellation value are shown.
(4) Click [Monitor update] to update the monitoring status.
(5) Click [File output] to save the monitored information as a CSV file.
Refer to section [3.13.1.2 Monitoring input/output status on DIDO Controllers (66DC) (5)].
The folder name is
c:¥ProgramFiles¥MntTool32¥Data.
[See section 5.7.]
NOTE:
The temperature is displayed in the unit (°C or °F) that has been selected at Maintenance Tools startup.