Multi-Tech Systems FR111 - Manual (Page 42)

42
6 Click on the DLCI numeric dialog box. Enter the DLCI number
that was provided by your service provider at subscription time.
To change the DLCI, click on the DLCI numeric dialog box and
back space through the default number and then enter your DLCI.
7 Click on the Management type option button supported by your
Frame Relay network. The Management type is supplied by your
service provider at subscription time.
For most applications, the default Management Parameters
should be adequate.
Polling Interval is the number of seconds for a polling cycle (i.e.,
the time period between each status enquiry message sent from
the MultiFRAD).
Full Status Counter displays a number between 1 and 255 that is
the number of polling cycles (minus one) before a full status is
requested from the network.
Error Threshold displays a number between 1 and 10 that is less
than or equal to the Monitored Event count.
Monitored Event displays a number that is between 1 and 10 that
is greater than or equal to the Error Threshold.
8 Click on the Committed Info Rate numeric box and enter the CIR
value provided by your service provider at subscription time.
9 Click on the Excess Burst Rate (Be) numeric box and enter the
Be value provided by your service provider at subscription time.
10 The Back to Back check box should normally remain unchecked.
11 Click on the Encapsulation Type you need. Mux Mode encapsu-
lation can be used only if the FRAD at the other end of the PVC is