Multi-Tech Systems FR111 - Manual (Page 45)

45
4 If the data port is being setup for Async mode of operation and a
port speed of 57.6K, initially the data port does not have to be
changed, proceed to step 6 to configuring the Trunk.
Data Port Configuration
1 - Async/Sync: Async
2 - Speed: 57600
3 - Word Length: 8
4 - Stop Bits: 1
5 - Parity: None
6 - Flow Control: CTS
7 - Enq/Ack Flow Control: Off
8 - Echo: Off
9 - Pacing: Off
10 - EIA Pass Through: Off
11 - Pass Xon: Off
S - Store All Configurations
M - Main Menu
P - Previous Menu
Selection : _
If the data port configuration needs to be changed, enter the
option number to be changed and a submenu is displayed.
Change the option to meet the conditions of your installation.
When the data port is configured to meet your site requirements,
proceed to step 6 to configure the Trunk.
5 Change the Sync Data Port Configuration to meet the conditions
of your installation by selecting the option needing change and a
submenu is displayed with your selections.
Data Port Configuration
1 - Async/Sync: Sync
2 - Speed: 57600
3 - Idle Condition: Flags
4 - NRZ/NRZI Encoding: NRZ
5 - CRC Preset: All 1s
6 - Inter-frame Timer: Off
S - Store All Configurations
M - Main Menu
P - Previous Menu
Selection : _
When the Sync Data Port is configured to meet your site require-
ments, enter the letter S and press ENTER to store all configura-
tions. Then enter the letter P and press ENTER to return to the
Configuration menu.