Multi-Link The Stick Voice/Fax/Modem Call Processor - Manual (Page 13)

2.2 INITIAL CHECK
Included with The Stick are additional items that make life a whole lot
easier. Please check the box and make sure you have:
l
The StickTM Voice/Fax/Modem Call Processor
l
One 12 Volt Class 2 Power Source
l
One Silver Modular Line Cord
If any of these items are missing, please alert the retailer from which you
purchased the unit and also Multi-Link, Inc. at 1-800-535-4651
POWER UP
The first thing you must do before programming The Stick is to “power
up” the unit. It is recommended that you choose a power outlet close to a
telephone wall jack. Plug the power supply (supplied) into the 110 volt
outlet and insert the barrel plug into the port labeled ::
USE ONLY WITH
12 VAC 0.8-1.0A
CLASS 2
POWER SOURCE
at the rear of the unit. The red light beside “The Stick” logo should be lit
at this time.
CONNECTING TO THE PHONE LINE
Before programming The Stick, you will need
to install it on your existing telephone line
and connect a touch-tone (DTMF) telephone
to the port labeled “VOICE 1" at the bottom
of the unit. A silver Modular Line Cord has
been supplied for connecting The Stick to a phone line. Plug one end of
the line cord into the port labeled “LINE”. Plug the other end into a
telephone wall jack. At this time you should hear dial tone when the
handset on your touch tone phone is lifted off-hook.
8