Multi-Link The Stick Voice/Fax/Modem Call Processor - Manual (Page 18)

Executing Audible “Read Back” With The Stick:
First, you must enter the programming mode by dialing "##7 7”. Then
press "*" and the Register Number you wish to read back.
An example:
*First, you press "# # 7 7” on your touch tone phone to enter the
programming mode.
*The Stick responds with a “PROCEED” tone.
*You press "* 0 5” (telling The Stick to audibly read back the value in
Register 5).
*The Stick transmits 2 ‘Beeps” signifying the value “0” (the feature is
turned off).
*After a short pause, The Stick will transmit an “OK” tone followed by a
“PROCEED” tone.
*At that time you may either “read back” or program any register.
For Registers Containing More Than A Single Value
Some registers can (or are required to) contain more than a single value,
i.e., Registers 11 to 15. Here’s a short example of what a “read back”
would sound like where more than 2 digits or symbols are programmed
in the register. Let’s say the register you want to “read back” is number
13, the Security Access Code for the MODEM port, and it is programmed
as "* 7 5”:
*You first enter programming (# # 7 7).
*Press "* 1 3" to “read back” Register 13.
*The Stick transmits "Beep Beep Bip (pause) Beep Bip Bip (pause)
Beep”. (Equivalent to * 75).
Stick immediately transmits the “OK” and “PROCEED” tones.
Note: You will receive an “Error” tone when entering an incorrect
Register Number on audible “read back”. Never fear-try again!
13