Multi-Link The Stick Voice/Fax/Modem Call Processor User Manual
Page 16
to factory preset. The Stick will answer with an “OK” tone followed
immediately by a “PROCEED” tone. Dial “80” to save and exit.
3.2 An Overview of Programming
This is “the big picture” for how to program The Stick.
Being the good consumer you are, you’ve read the manual thoroughly
(NOT!), penciling in the feature changes on your
. You call your mom (a local call) and ask her to
lay the phone down for a moment while you program this neat new call
processor you’ve just purchased. She says OK.
You’ve decided to reprogram the Security Access Code for the MODEM
port, turn the “
2) You change the SAC for the MODEM port to “007” by dialing 13007.
“13” selects Register
13
(Security Access Code for MODEM port) and
007 is the new SAC.
The Stick Response: Answers with an “OK” tone, then a “PROCEED”
tone. You have 30 seconds to begin the next command.
3) You change the “Unrestricted Manual Transfer” feature to “OFF”
(factory preset “ON” ) by dialing 070. “07” selects Register 7 and "0"
turns the feature off.
The Stick Response: Answers with an “OK” tone, then a “PROCEED”
tone. You have 30 seconds to begin the next command.
4)
You change the “Pulse Detect” feature to “ON” (factory preset “OFF”)
by dialing 051. "05" selects Register 5 and "1" turns the feature on.
1) Since five seconds has more than elapsed since you initiated the call to
The Stick Response: Answers with an “OK” tone, then a “PROCEED”
your mom, you can enter the programming mode. You dial " # # 7 7”
tone. You have 30 seconds to begin the next command.
on your touch tone phone connected to the “VOICE 1"' port. 5) You have finished programming the desired feature changes and wish
The Stick Response: Answers with a “PROCEED” tone. The LED is
to save them to nonvolatile memory and exit the programming mode.
blinking very rapidly. You have 30 seconds to begin the next command. 11
You dial “80”.