Microsoft G7VP2 - Manual (Page 44)

44
3
Award BIOS Setup Utility
3.1.4 Power Management Setup
The Power Management Setup allows you to configure your system to
most effectively save energy. If you like to use the soft power down
feature of Windows  95/98, you must enable the Power Management
field below. Select Min. Power, Max. Power or User Defined. Either one
can be used as long as it is NOT disabled.
The settings on the screen are for reference only. Your version may not be
identical to this one.
ROM PCI/ISA BIOS
POWER MANAGEMENT SETUP
AWARD SOFTWARE, INC.
Power Management
PM Control by APM
Video Off Method
Video Off After
Standby Mode
Suspend Mode
HDD Power Down
Soft-Off by PWRBTN
Resume on Alarm : User Define
: Yes
: DPMS
: Suspend
: Disabled
: Disabled
: Disabled
: Instant-Off
: Disabled
ESC
F1
F5
F6
F7 : Quit
: Help
: Old Values
: Load Fail-Safe Settings
: Load Optimal Settings
PU/PD/+/-
(Shift) F2
: Select Item
: Modify
: Color
↑ ↓ → ←
** PM Events **
IRQ3 (COM 2)
IRQ4 (COM 1)
IRQ5 (LPT 2)
IRQ6 (Floppy Disk)
IRQ7 (LPT 1)
IRQ8 (RTC Alarm)
IRQ9 (IRQ2 Redir)
IRQ10 (Reserved)
IRQ11 (Reserved)
IRQ12 (PS/2 Mouse)
IRQ13 (Coprocessor)
IRQ14 (Hard Disk)
IRQ15 (Reserved)
: Primary
: Primary
: Primary
: Primary
: Primary
: Disabled
: Secondary
: Secondary
: Secondary
: Secondary
: Primary
: Primary
: Disabled
sound of the alarm resembles that of the siren of an ambulance.
The “failure detection” circuit requires a fan to operate at
greater than 3600 RPM.
+3.3V, +5V and +12V Voltages
Set these fields to “Monitor” if you want the system board to
detect the output voltage of the power supply. If the output
voltage is over or under +3.3V/+5V/+12V (±10%), an alarm
will sound warning you of voltage issue. The sound of the alarm
is continuous low to high beeps but shor ter than the
temperature alarm. Some of the most common causes leading
to unstable output voltage of a power supply are:
- The power supply is not functioning normally. Turn off your
system and replace the power supply.
- The AC input from the power outlet to your system is
unstable. Please consult your MIS department or an
electrician.