Microsoft G7VP2 - Manual (Page 49)

49
3
Award BIOS Setup Utility
PCI IRQ Actived By
This category is used to set the method by which the PCI bus
recognizes that an IRQ service is being requested by a device. Under
all circumstances, you should retain the default configuration unless a
different setting is needed.
Assign IRQ for VGA
When Enabled, the system automatically assigns an IRQ for the VGA
card installed. Your VGA card will need an IRQ only when using the
video capture function of the card. If you are not using this function
and a new device requires an IRQ, you can set this function to
Disabled. The IRQ (previously occupied by the VGA card) will be
available for your new device.
Note:
When Disabled, a “Yellow” mark will appear in Windows  95/98’s
Device Manager.
PCI Slot 1 Use IRQ and PCI Slot 2 Use IRQ
By default, an IRQ will automatically be assigned to each PCI slot.
You may manually assign an IRQ to these slots by selecting one of
the available options.