Microsoft G7VP2 - Manual (Page 60)

60
4
Supported Softwares
4.2 System Health Monitor Utility
The system board comes with a System Health Monitor utility. This
utility shows the current temperature of the processor, power
voltages, and CPU/Chassis fan speed.
The utility also allows you to manually set the range of the
processor’s temperature, power voltages, and CPU/Chassis fan
speed. If the settings/values are over or under the set range, an
error message will pop-up and an alarm will sound. There are three
types of sound for the three different failure alarms (temperature,
voltage and fan). Refer to the Chipset Features Setup (Chapter 3)
section for details.
When you hear a failure alarm, you must power off your computer
and check the following: processor fan/heatsink, chassis fan and
power supply. We recommend that you use the “Default Setting”
which is the ideal setting that would keep the system in good
working condition.
Genesys Logic System Health Monitor (for VIA)
The time
interval for
monitoring
the system
User Setting
Quit
Update w/o Save
Default Setting
Update and Save
Polling Interval:
Temperature
CPU Over-Heat Temperature:
4 Seconds
80
6
CPU Hysterisis Temperature: 75
CPU Temperature: 29
Celsius
Fahrenheit
Voltage (V)
High Limit: Low Limit: Current Voltage:
3.3V Values 3.60
12V Values 13.20
5V Values 5.50
3.35
12.91
5.08
3.00
10.80
4.50
Minimize when Startup
Alarm when
CPU Over Heat
3.3V Abnormal
12V Abnormal
5V Abnormal
Fan (RPM)
Low Limit:
2000
2000
CPU Fan
Chassis Fan
Current Speed:
5454
3287
CPU Fan Abnormal
Chassis Fan Abnormal
C P U
temperature
limit
Current
temperature
of the CPU
Output
voltage
limit
CPU/
Chassis
fan speed
limit
W h e n
enabled,
this screen
will minimize
and display a
histogram
icon after
boot-up
These
items when
enabled will
alert you in
case of
detected
failure