Matsushita CF-W4HWEZZBM - Manual (Page 47)

0 1mm
Inserts in ditch
Inserts in latch
Inserts in the table side.
Rib outside suiting
0 1mm
Rib outside suiting
Processing of Speaker Cable Speaker installation
Speaker Box
Secure 2mm or more for the space in each rib
and the soldering part.
Rib
Soldering Part
2mm or more
Rib
Rib
Rib
2mm or more
Inserts in Ditch
6.3.7. Assembly of Antenna Board Part
Place between the bottom base
and install.
Antenna Cable (L)
Install DC Jack in bottom
Process the cable
with the boss between ribs.
Process the cable to the ditch
of the Bottom Case.
The terminal must become
straight below.
Antenna Cable (L)
Boss
Bottom Case
Install the Antenna Board in the Bottom Case.
And process remainder of the Antenna Cable as shown in the figure below.
Line processing of Antenna Cable (L)
DC Jack Holder
The under latch is hooked
the Bottom Case
The under latch is hooked
the Bottom Case
Antenna Cover(L)
The upper side is close with
the under latch is hooked
the Bottom Case
47