Matsushita CF-W4HWEZZBM - Manual (Page 51)

6.3.12. Assembly of Disk Cover
0 1mm
0 1mm 0 1mm
a b c
Insert the hook in the corner hole.
0 1mm
0 mm
Disk Angle
Disk Angle
Disk Angle Sheet B Disk Angle Sheet A
Disk Angle Sheet C
0 1mm 0 1mm
0 1mm
Disk Angle Cushion
Disk Angle FPC Cover
Disk Angle Cushion
Disk Angle
Cushion
Arrange Disk Cover Shaft at the left of the bend
of the Disk Angle.
Insertion into a slot makes
PIN slide.
<Figure after installations>
Insert the hook in the corner hole.
DXQT2+D25FNL
(N8)
Installation of Disk Cover
Disk Angle Sheet A is pasted.
Disk Angle FPC Cover is pasted.
PET Tape is pasted.
Disk Angle Sheet B/C is pasted.
PET Tape
Installation of various dampers on Disk Angle
Disc Cover
PAD Cover Ring
Arm spring for
Disk Cover
Convex part
Latch
Convex part
Insert under
the Hook
Assembly of Disk Cover
Installation of PAD Cover Ring Installation of Disk Cover Shaft
Pin 2 Pin 1
Insert two Convex parts in the hole of Disc Cover.
Hang two latch on Disc Cover.
Insert the Arm Spring for the Disk Cover in the Disk Cover.
Insert pin 1 of the Disk Cover Shaft through the
inside diameter of the Spring.
Pin 2 of the Disk Cover Shaft must be slided,
and insert in the hole of the Disk Cover.
Disk Cover Shaft
51