Matsushita CF-W4HWEZZBM - Manual (Page 54)

3. Screw tightening of Bottom Case
1.The screw tightening is done in the undermentioned order.
3-1. DXHM0039ZA(E:N6) is tightened.No.1 to No.3
3-2. DXHM0057ZA(C:N7) is tightened. No.4,No.5
3-3. DXQT2+E12FNL(F:N11) is tightened. No.6 to No.9
3-4. DXQT2+E10FNL(D:N10) is tightened. No.10
3-5. DXQT2+D4FNL(H:N9) is tightened. No.11
3-6. DRHM0092ZA(B:N4) is tightened. No.12 to No.14
Screw (H)
Screw (E)
Screw (C)
Screw (D)
Screw (F)
Screw (E) Screw (F)
Screw (F)
Screw (B)
Screw (E)
Screw (B)
Screw (B)
Screw (C)
Screw (F)
6.3.15. Specification of affixation of PET tape to Heat Spreader
1~2mm
1~2mm
<The Main Board Side> <The Back Completion Chart>
Heat Radiation Grease(G-751)
Spread with a treatment device.
Heat Spreader
PET Tape
PET Tape
The extent that length
remains pastes on an
opposite side.
The extent that length
remains pastes on an
opposite side.
Never touch the aluminum edge part directly by bare-handed when the part of aluminum with a thin all
surroundings bends. Correct in that case with a radio pincers etc. and instal.
54