Connecting to a speaker ("spkr"), Connecting to a sound card ("spkr"), Connecting to power ("pwr") – Multi-Tech Systems MT5634ZBAV User Manual
Page 50: User guide, Connecting to a speaker (“spkr”), Connecting to a sound card (“spkr”), Connecting to power (“pwr”)
User Guide
40
phone should have a 1/8-inch stereo plug and should not be amplified.
Do not use a microphone with a mono jack
Note: To avoid feedback, place the microphone away from your speakers.
Connecting to a Speaker (“SPKR”)
To use the MT5634ZBAV modem for speakerphone or voice mail appli-
cations, plug an amplified speaker with a 1/8-inch stereo plug into the
SPKR jack of the modem. If you use a mono speaker, you must change
the speaker mode jumper as described in Chapter 2.
Connecting to a Sound Card (“SPKR”)
If a sound card and speakers are installed in your system, you can con-
nect the SPKR jack of the modem to the LINE IN jack of the sound
card. Use a male-to-male stereo patch cord with 1/8-inch plugs.
Connecting to Power (“PWR”)
Low voltage DC power is supplied to the modem through a modular
power supply included with the modem. Plug the power supply module
into a convenient AC power outlet or surge protector. Plug the connector
on the other end of the power cord into the PWR jack on the modem. A
power ON/OFF switch is located on the right side of the modem.
Note: Use only the power supply supplied with the modem. Use of any
other power supply will void the warranty and could damage the modem.
As soon as you apply power to the modem, it will perform a diagnostic
self-test, indicated by the speed LEDs flashing in sequence for approxi-
mately two seconds, after which the 56 indicator should light. If this