User guide – Multi-Tech Systems MT5634ZBAV User Manual
Page 60
User Guide
50
Dial string modifiers:
L Redial last number. (Must be placed immedi-
ately after ATD.)
P Pulse-dial following numbers in command.
T Tone-dial following numbers in command (de-
fault).
V Switch to speakerphone mode and dial the
following number. Use ATH command to hang
up.
W Wait for a new dial tone before continuing to
dial. (X2, X4, X5, X6, or X7 must be selected.)
,
Pause during dialing for time set in register S8.
;
Return to command mode after dialing. (Place
at end of dial string.)
!
Hook flash. Causes the modem to go on-hook
for one-half second, then off-hook again.
@ Wait for quiet answer. Causes modem to wait
for a ringback, then 5 seconds of silence,
before processing next part of command. If
silence is not detected, the modem returns a
NO ANSWER code.
^ Disable data calling tone transmission.
$
Detect AT&T call card “bong” tone. The char-
acter should follow the phone number and
precede the user’s call card number:
ATDT1028806127853500$123456789
Command:
DS=
y Dial Stored Telephone Number
Values:
n = 0–3
Default:
none
Description:
Dial a number previously stored in directory num-
ber
y by the &Zy=x command.
Example: ATDS=3