Starting the engine, Starting the engine -4, Form no.8at5-ea-09e – Mazda 2010 RX-8 User Manual

Page 146: Starting and driving, Caution

Advertising
background image

Black plate (146,1)

ACC (Accessory)

The steering wheel unlocks and some
electrical accessories will operate.

ON

This is the normal running position after
the engine is started. Some indicator
lights/warning lights should be inspected
before the engine is started (page 5-40).

NOTE

(Gasoline engine models)
When the ignition switch is turned to the ON
position, the sound of the fuel pump motor
operating near the fuel tank can be heard. This
does not indicate an abnormality.

NOTE

(With headlight auto-leveling)
When the ignition switch is turned to the ON
position, the sound of the headlight leveling
motors operating at the front of the engine
compartment can be heard. This does not
indicate an abnormality.

START

The engine is started in this position. It
will crank until you release the key. It
then returns to the ON position.

qIgnition Key Reminder

If the ignition switch is in the LOCK or
ACC position with the key inserted, a
continuous beep sound will be heard
when the driver's door is opened.

Starting the Engine

NOTE

Engine-starting is controlled by the spark
ignition system.
This system meets all Canadian Interference-
Causing Equipment Standard requirements
regulating the impulse electrical field strength
of radio noise.

1. Occupants should fasten their seat

belts.

2. Make sure the parking brake is on.

3. Depress the brake pedal.

4. (Manual transmission)

Depress the clutch pedal all the way
and shift into neutral.
Keep the clutch pedal depressed while
cranking the engine.
(Automatic transmission)
Put the vehicle in park (P). If you must
restart the engine while the vehicle is
moving, shift into neutral (N).

NOTE

(Manual transmission)
The starter will not operate unless the clutch is
depressed sufficiently.
(Automatic transmission)
The starter will not operate if the shift lever is
not in P or N.

5. Turn the ignition switch to the START

position and hold (up to 10 seconds at
a time) until the engine starts.

CAUTION

Do not try the starter for more than
10 seconds at a time. If the engine
stalls or fails to start, wait 10 seconds
before trying again. Otherwise, you
may damage the starter and drain
the battery.

5-4

Driving Your Mazda

Starting and Driving

RX-8_8AT5-EA-09E_Edition1 Page146
Wednesday, April 15 2009 10:33 AM

Form No.8AT5-EA-09E

Advertising