Changing the tire, Changing the tire -11, Form no.8at5-ea-09e – Mazda 2010 RX-8 User Manual

Page 313: Flat tire, Caution, Warning

Advertising
background image

Black plate (313,1)

NOTE

When checking the tire inflation pressure with
the tire pressure gauge on the compressor unit,
make sure the compressor switch is turned off.

21. If the tire inflation pressure remains

stable, the tire repair is complete.
Drive the vehicle with care to an
Authorized Mazda Dealer to have the
tire replaced.

CAUTION

Ø A tire that has been temporarily

repaired with the tire sealant
cannot be reused. Mazda
recommends replacing the tire
with a new one.

Ø The wheel can be reused after any

sealant adhering to it is wiped off
and carefully inspected. However,
replace the tire valve with a new
one.

qInspecting the IMS Emergency

Flat Tire Repair Kit

Inspect the emergency tire repair kit at
regular intervals.

l

Check the tire sealant period of
effective use.

l

Check the operation of the tire
compressor.

NOTE

The tire sealant has a period of effective use.
Check the period of effective use indicated on
the bottle label and do not use it if it has
expired. Have the tire sealant replaced at an
Authorized Mazda Dealer before the period of
effective use has expired.

Changing the Tire

WARNING

Be sure to follow the directions for
changing a tire, and never get under a
vehicle that is supported only by a jack:

Changing a tire is dangerous if not
done properly. The vehicle can slip off
the jack and seriously injure
someone.

Never allow anyone inside a vehicle
supported by a jack:

Allowing someone to remain in a
vehicle supported by a jack is
dangerous. The occupant could cause
the vehicle to fall resulting in serious
injury.

CAUTION

(With Tire Pressure Monitoring
System)
The wheels equipped on your Mazda
are specially designed for installation
of the tire pressure sensors. Do not
use non-genuine wheels, otherwise it
may not be possible to install the tire
pressure sensors.

NOTE

l

Make sure the jack is well lubricated before
using it.

(With Tire Pressure Monitoring System)

l

Be sure to register the tire pressure sensor
ID signal code whenever tires or wheels are
changed (page 5-33).

1. Park on a level surface off the right-of-

way and firmly set the parking brake.

2. Put a vehicle with an automatic

transmission in Park (P), a manual
transmission in Reverse (R) or 1, and
turn off the engine.

In Case of an Emergency

Flat Tire

7-11

RX-8_8AT5-EA-09E_Edition1 Page313
Wednesday, April 15 2009 10:34 AM

Form No.8AT5-EA-09E

Advertising