Mazda 2010 RX-8 - Manual (Page 288)

Black plate (288,1)
3. Prompt:
“Select one of the following:
pairing options, confirmation prompts,
select phone, language, or passcode...,
or say
“cancel” to return to main
menu.
”
4. Say: [Beep]
“Confirmation prompts”
5. Prompt:
“Confirmation prompts are
on/off. Would you like to turn
confirmation prompts off/on?
”
6. Say: [Beep]
“Yes”
7. Prompt:
“Confirmation prompts are
off/on, returning to main menu.
”
qVoice Recognition Learning
Function (Speaker Enrollment)
The voice recognition learning function
enables voice recognition appropriate to
the characteristics of the user's voice.
If the recognition of the voice input
commands to the system is not adequate,
this function can largely improve the
system's voice recognition of the user. If
your voice can be recognized sufficiently
without using this function, you may not
realize the added benefit of the function.
To register your voice, the voice input
command list must be read out. Read out
the list when the vehicle is parked.
Perform the registration in as quiet a place
as possible (page 6-59).
The registration must be performed
completely. The required time is a few
minutes. The user needs to be seated in
the driver's seat with the voice input
command list for voice recognition
learning open to the page indicated below.
1. Press the voice recognition/hands-free
switch with a short press (without
navigation system) or a long press
(with navigation system).
NOTE
For vehicles with the navigation system, you
can also press the voice recognition/hands-free
switch with a short press and say: [Beep]
“Telephone” or “Phone”.
2. Say: [Beep]
“Voice training”
3. Prompt:
“This operation must be
performed in a quiet environment while
the vehicle is stopped. See the owner's
manual for the list of required training
phrases. Press and release the phone
button when you are ready to begin.
Press and hold the phone button to
cancel at any time.
”
4. Press the voice recognition/hands-free
switch with a short press.
5. The voice guidance reads out the voice
input command number (refer to the
voice input command list for voice
recognition learning). (Ex.
“Please read
phrase 1
”)
6. Say: [Beep]
“0123456789” (Say the
voice input command for voice
recognition learning (1 to 8) according
to the voice guidance.)
7. Prompt:
“Speaker enrollment is
complete, returning to main menu.
”
Voice input command list for voice
recognition learning
When reading out, the following points
must be observed:
l Read out the numbers one at a time
correctly and naturally.
(For example,
“1234” must be read out
“one, two, three, four”, not “twelve, thirty
four
”.)
l Do not read out parentheses.
“ (” and
hyphens
“-” are used for separating
numbers in a phone number.
Ex.
6-74
Interior Comfort
Bluetooth Hands-Free
RX-8_8AT5-EA-09E_Edition1 Page288
Wednesday, April 15 2009 10:33 AM
Form No.8AT5-EA-09E