Mazda 2010 RX-8 - Manual (Page 42)

Black plate (42,1)
3. Push the child-restraint system firmly
into the vehicle seat. Be sure the belt
retracts as snugly as possible. A
clicking noise from the retractor will be
heard during retraction if the system is
in the automatic locking mode. If the
belt does not lock the seat down tight,
repeat this step.
NOTE
Inspect this function before each use of the
child-restraint system. You should not be able
to pull the shoulder belt out of the retractor
while the system is in the automatic locking
mode. When you remove the child-restraint
system, be sure the belt fully retracts to return
the system to emergency locking mode before
occupants use the seat belts.
4. If your child-restraint system requires
the use of a tether strap, refer to the
manufacturer's instructions to hook and
tighten the tether strap.
Anchor bracket location
Tether strap position
Anchor
bracket
Tether
strap
2-30
Essential Safety Equipment
Child Restraint
RX-8_8AT5-EA-09E_Edition1 Page42
Wednesday, April 15 2009 10:32 AM
Form No.8AT5-EA-09E