Form no.8at5-ea-09e, Starting and driving, Caution – Mazda 2010 RX-8 User Manual

Page 169

Advertising
background image

Black plate (169,1)

CAUTION

Ø The DSC may not operate correctly

unless the following are observed:

Ø

Use tires of the correct size
specified for your Mazda on all
four wheels.

Ø

Use tires of the same
manufacturer, brand and tread
pattern on all four wheels.

Ø

Do not mix worn tires.

Ø The DSC may not operate correctly

when tire chains are used or a
temporary spare tire is installed
because the tire diameter changes.

Ø If repair or replacement of the

steering or other surrounding
equipment is necessary, have it
done at an Authorized Mazda
Dealer. If the center position of the
steering deviates, the DSC may not
operate correctly because there is
a sensor in the steering which
detects driving conditions.

qTCS/DSC Indicator Light

This indicator light stays on for a few
seconds when the ignition switch is turned
to the ON position. If the TCS or DSC is
operating, the indicator light flashes.

If the light stays on, the TCS or DSC may
have a malfunction and they may not
operate correctly. Take your vehicle to an
Authorized Mazda Dealer.

qDSC OFF Indicator Light

This indicator light stays on for a few
seconds when the ignition switch is turned
to the ON position.
It also illuminates when the DSC OFF
switch is pressed and TCS/DSC is
switched off (page 5-28).

If the light stays on when the TCS/DSC is
not switched off, take your vehicle to an
Authorized Mazda Dealer. The dynamic
stability control may have a malfunction.

NOTE

If the battery is disconnected or a fuse is
replaced, the DSC will be inoperable. In this
case, the DSC OFF indicator light flashes and
the TCS/DSC indicator light illuminates.
To make the DSC operable, do the following
procedure with the battery connected.

1. Turn the ignition switch to the ON position.

2. Turn the steering clockwise fully, then turn

it counterclockwise fully.

3. Make sure the DSC OFF indicator turn off.

4. Turn the ignition switch to the OFF

position, then turn it to the ON position
again.

5. Make sure the TCS/DSC indicator light

turns off.

If the TCS/DSC indicator light and the DSC
OFF indicator light remain illuminated even
after turning the ignition switch to the ON
position, consult an Authorized Mazda Dealer.

Driving Your Mazda

Starting and Driving

5-27

RX-8_8AT5-EA-09E_Edition1 Page169
Wednesday, April 15 2009 10:33 AM

Form No.8AT5-EA-09E

Advertising