Magnetek 188-10130 - Manual (Page 41)

RVS-DX, Digital Soft Starter Instruction Manual—4/01/04
6-5
* Requires an option card for these parameters to be displayed. If there are no option cards, the display will
read,“Option Card—Not Installed”.
DISPLAY MODE
Parameter Description Default Value Range Access
% of MOTOR FLA
MOTOR INSULATION*
THERMISTOR RES.*
ANALOG OUTPUT
The operating current as a % of the motor FLA
Displays the insulation level of the motor’s windings
Displays the motor thermistor resistance
Normal=analog output increases with increasing current
Inverted=analog output decreases with increasing current
n/a
Option card-not installed
Option card-not installed
Option card-not
installed*
0-100%
?
?
Normal or Inverted
Display only
Option card
Option card
Option card
SERVICE MODE
Parameter Description Default
Access: To Enter or Exit the Service Mode press “Mode” &T simultaneously.
STORE ENABLE DEFAULT
PARAMET.
RESET STATISTICS
PROGRAM VERSION
VOLTAGE ADJUST.
CURRENT ADJUST.
Reset ALL parameters to default settings
Reset statistical data.
View the software version.
Factory calibration of phase to phase voltage.
Factory calibration of current.
Press “Mode” & Store simultaneously to save default
parameters.
Press “Reset” & “Store” simultaneously to reset
statistic parameters.
STRT.DN-xxxxxx
xxx VOLT
xxx% of FLC