Magnetek 188-10130 - Manual (Page 5)

RVS-DX, Digital Soft Starter Instruction Manual—4/01/04
ii
Disclaimer of Warranty
Magnetek, hereafter referred to as Company, assumes no responsibility for improper programming
of a soft starter by untrained personnel. A soft starter should only be programmed by a trained
technician who has read and understands the contents of this manual. Improper programming of a
soft starter can lead to unexpected, undesirable, or unsafe operation or performance. This may result
in damage to equipment or personal injury. Company shall not be liable for economic loss, property
damage, or other consequential damages or physical injury sustained by the purchaser or by any
third party as a result of such programming. Company neither assumes nor authorizes any other
person to assume for Company any other liability in connection with the sale or use of this product.
IMPORTANT
1. Read this manual carefully and follow its instructions before operating equipment.
2. Installation, operation, and maintenance should be in strict accordance with this manual,
national codes and good practice. Installation or operation not performed in strict accordance
with these instructions will void manufacturer’s warranty.
3. Disconnect all power inputs before wiring or servicing the equipment.
4. After installation, verify that no hardware (bolts, washers, etc.) have fallen into the power
section.
WARNING
1. Internal components and printed circuit boards are at main potential when the RVS-DX is
connected to main power. This voltage is extremely dangerous, and may cause death or severe
injury if contacted.
2. The control PCB employs CMOS ICs that are easily damaged by static electricity. Use proper
electrostatic discharge (ESD) procedures when handling the control PCB.
3. When the RVS-DX is connected to main power, even if control power is not connected and the
motor is stopped, full voltage may appear on the RVS-DX’s output terminals.
4. RVS-DX must be grounded to ensure correct operation, safety, and to prevent damage.
5. Power factor capacitors must NOT be connected to the output side of the RVS-DX.
WA R N I N G
Improper programming of a soft starter can lead to unexpected, undesirable, or unsafe
operation or performance.