Maxtor NVR-2028 - Manual (Page 14)

12
xi. Push the Setup button to save the setup data.
xii. When the words "WAITING" flash on and off at the bottom of the screen, if the screen
goes blank, you can press the "Power" button to close the device and press it again to
resume its operation.
6. Go to the IP/ACCOUNT option on the LANCAM SETUP page in the NVR setup menu. Choose
any channel between 1 to 8 channels to set up the LANCAM IP address. Push the Search
button to find all LANCAM IP addresses and push the Enter button to choose one of them to
set the channel. Repeat step 6 to set each LANCAM IP address.
NOTE: You need to use an RS-232 cable enclosed in our package and not any other cable,
or an error may happen.
NOTE: Once the LANCAM power cord is plugged into the outlet, it will scan the AP or NVR
device automatically and obtain an IP address from a DHCP server. This action will
continue until a DHCP server is found. If the LANCAM cannot find it after two minutes,
its IP address will change to static IP mode as 192. 168. 1. 168. The user can push the
DHCP DIP switch on the side of the LANCAM down and up once to reset the static IP
to dynamic IP (DHCP client).
NOTE: If the DHCP server of the NVR-2028 is activated, the default NVR IP address is set as
192. 168. 1. 205.
3.1.2 The Wireless Network Structure of the NVR and Its LANCAMs
The illustration below shows the wireless network of a WIRELESS NVR-2028 device connected with its
LANCAM client units, whose maximum number is eight.
SD Card
RS-232
ALARM DC12V AUDIO MONITOR
ANT
I/O
Audio in
Video in
Monitor NVR
(UP TO 8 WIRELESS LANCAMS CONNECTION)
wireless Lancam
IRIS 1. AES
2. DC IRIS 3. DHCP 4. STATIC IP
ALC POWER LAN
wireless Lancam
IRIS 1. AES 2. DC IRIS
3. DHCP 4. STATIC IP
ALC POWER LAN
wireless Lancam
SD card
wireless Lancam
SD card
WAN LAN