Maxtor NVR-2028 User Manual
Page 48
46
STATUS:
Show WAN leased IP table.
CONNECT TYPE:
This enables you to choose your connection style.
AUTO: Dynamic IP from DHCP server, no dialing necessary.
MANUAL: Static IP, no dialing needed. Enter the Wide Area Network (WAN) IP Address, Subnet
Mask, ISP Gateway Address, and DNS values. You can obtain all the above data from
your ISP.
PPPOE: Needs dialing. If your ISP uses Point-to-Point Protocol over Ethernet (PPPoE), then
choose it; PPPoE allows your ISP to authenticate your connection by requiring you to
submit a user name and password.
NAME:
Move the focus to "ENTER" and go to the "NAME SETTING" page.
This enables you to set the "HOST" and "DOMAIN" names.
NOTE: Provide a host name (also called system name or account name) and the ISP domain name
(e.g. www.isp.com) if your ISP requires this information.
IP SETTING:
Enter and go to the "WAN IP SETTING" page.
Set the "WAN IP", "WAN MASK", "ISP GATEWAY", "DNS 1”, “DNS 2”, and “DNS 3" addresses.
NOTE: If CONNECT TYPE is set to MANUAL, this function will work.
VIRTUAL SERVERS:
Enter the "VIRTUAL SERVER SETTING" page. Set the "PUBLIC PORT", "PRIVATE IP", "PRIVATE
PORT", and "PROTOCOL" entries.
To allow traffic from the Internet to enter your local network to connect internal devices, such as NVR or
LANCAM, you will need to open up ports or the router will block the request. For example, consider an
assumed LAN network with two devices, NVR and LANCAM, that have LAN IP addresses 192.168.1.205
and 192.168.1.168, respectively. The http ports of the two devices are of the default settings (80).
NVR's WAN port connects to the Internet with a WAN IP 100.0.0.2.
Two public ports, say 2000 and 2001, are assigned to NVR and LANCAM for identifying internal devices
from the Internet.
The settings should be set like the followings.
Public Private
Private
Protocol
Port
IP
Port
2000 205 80
TCP
2001
168
80
TCP
The URLs are used to connect to NVR and LANCAM listed below:
NVR → http://100.0.0.2:2000
LANCAM → http://100.0.0.2:2001
COMM SETTING
WIIRELESS : SET
WAN SETTING
: SET
NET IP
: SET
NET DHCP
: SERVER
LEASED IP TABLE : ENTER
IP POOL RANGE : SET
COMM ID
: 01
RS232
: ON
MAIN PAGE
SET NETWORK
WAN SETTING
STATUS :
ENTER
CONNECT TYPE : AUTO
NAME
:
SET
IP SETTING
: SET
VIRTUAL SERVERS : SET
COMM PAGE
SET WAN CONNECTION TYPE