Maxtor NVR-2028 - Manual (Page 47)

45
LANCAM SETUP:
This option is used to selects either RS232 or WLAN. If you wish to transfer information to the wireless
LANCAM via the NVR, you must select the LANCAM SETUP option to configure the wireless or wired
(RS-232) function installation.
RS232 : This option provides the wired function. "RS232" option can set wireless settings to a
wireless LANCAM. If there are more than one LANCAM to be set, you must set it one
by one. (Please refer to chapter 3. INSTALLATION section.)
NOTE: Please set the RS-232 option to ON in the COMMUNICATION page of the setup
menu before you select this option.
WLAN : This is the wireless option. "WLAN" option can only be used to transmit modified
wireless settings to a group of LANCAMs which currently is connected with NVR. Make
sure all of LANCAM can be connected successfully, i.e. NVR can receive images from
LANCAMs, before using this function. In the beginning of the process, the connectivity
testing is performed to ensure that the settings can transmit to all of LANCAMs. If any
of LANCAMs fails in the testing, the process is aborted.
WAN SETTING:
This helps you make the settings that enable you to enter the Internet.
WIRELESS SETTING
OPERATION : SET
PRIVACY
: SET
LANCAM SETUP : RS232
COMM PAGE
SET LANCAM WIRELESS SETTING
MAIN MENU
LAN CAMERA
RECORD / BANDWIDTH
CLOCK / TIMER / SEQ
ALARM
COMMUNICATION
DISK
SYSTEM
GOTO COMM PAGE
COMM SETTING
WIIRELESS : SET
WAN SETTING : SET
NET IP : SET
NET DHCP : SERVER
LEASED IP TABLE : ENTER
IP POOL RANGE : SET
COMM ID : 01
RS232 : ON
MAIN PAGE
SET NETWORK