Interphase Tech 4538 - Manual (Page 35)

Chapter 1: Hardware Description
4538 Hardware Reference Manual 13
Figure 1-3. Board CPU_LEDs
The PCI Bridge
A dedicated PCI bridge, the Tundra PowerSpan, controls the interface between the card and
the host 32-bit PCI bus.
The PowerSpan implements all the registers needed by the PCI 2.2 standard, providing the
Plug-and-Play capability, as well as the Hot-Swap Friendly capabilities. It supports Target
and Master accesses between the PCI bus and the local 60x bus.
It also implements windows and different mechanisms to interface between the PCI host
and the card. Exchanges can use the following elements from the PowerSpan:
• Runtime registers (mailboxes, doorbells, semaphores)
• Four memory windows from the PCI memory space to the Local memory space
• Eight memory windows from the Local space to the PCI memory or I/O space
• Four independent bidirectional DMA engines
• An I²O messaging unit
This chip implements FIFO buffers for all the exchanges through the different windows
between the two buses, so that the local bus clock is independent from the PCI bus clock.
All the PowerSpan internal registers are grouped in a 4 KB memory space that can be
accessed by the PCI host and the local processor. On the PCI side, the PCI base address of
this register space is defined by PCI configuration register PCIBAR1 (offset 0x14). On the
local side, the local base address has been conventionally fixed to 0xF0020000.
Table 1-14. User-Programmable LED Control Ports
&30 ,2 6LJQDO 1DPH 'HVFULSWLRQ
3'  &38B/(' %RDUG XVHUSURJUDPPDEOH JUHHQ /(' &38 /(' FRQWURO  2Q  2II
3'  &38B/(' %RDUG XVHUSURJUDPPDEOH JUHHQ /(' &38 /(' FRQWURO  2Q  2II
3'  &38B/(' )URQW SDQHO XVHUSURJUDPPDEOH JUHHQ /(' /(' FRQWURO  2Q  2II
3'  &38B/(' %RDUG XVHUSURJUDPPDEOH UHG /(' &38 /(' FRQWURO  2Q  2II
3'  &38B/(' %RDUG XVHUSURJUDPPDEOH UHG /(' &38 /(' FRQWURO  2Q  2II
* 5 5 *
&38 &38 &38 &38
/(' /(' /(' /('