JVC HR-XVS20EK - Manual (Page 16)

Filename [XVS20EK_06Index.fm]
Masterpage:Left0
16
Page 16 March 28, 2003 6:55 pm
INITIAL SETTINGS
Auto Set Up
Auto Channel Set/Auto Clock Set/
Auto Guide Program Number Set
A
Turn on the unit.
Press 1 on the unit or remote control.
B
Perform Auto Set Up.
The AUTO SET/T-V LINK display appears on the front
display panel and/or on the TV screen.
On the front display panel
Press rt to select “Auto” and press OK or e.
● When you have connected the unit to a TV offering T-V Link
via a fully-wired 21-pin SCART cable (
੬
pg. 15) and the TV is
turned on, the unit automatically performs the Preset
Download (
੬
pg. 18) even if you select “Auto” or “AUTO
SET” for Auto Set Up function.
After the 1 button on the unit or remote control is pressed
for the first time to power on the unit, the Auto Set Up
function sets the tuner channels, clock and Guide Program
numbers automatically.
Before starting, make sure of the following:
● The TV aerial cable should be connected to the unit.
● The unit’s mains power cord should be connected to a
mains outlet.
● The TV should be set to its AV mode (with AV connection
੬
pg. 15) or UHF channel 36 (with RF connection
੬
pg. 15).
● Slide the TV/S-VHS/DVD switch to the right.
On the on-screen display
Press rt to move the
highlight bar (pointer) to
“AUTO SET” and press OK or
e.
“Auto” blinks on the front display panel; do NOT press
any button on the unit or remote control until the front
display panel shows either the display as illustrated in
step
C or “– –:– –” as illustrated on page 19.
● If you are using the on-screen
display, the AUTO SET
screen will appear. As Auto
Set Up progresses, the “q”
mark on the TV screen
moves from left to right.
Beginning End
XVS20EK_01.book Page 16 Friday, March 28, 2003 7:00 PM