JVC HR-XVS20EK - Manual (Page 18)

Filename [XVS20EK_06Index.fm]
Masterpage:Left+
18
Page 18 April 1, 2003 3:39 pm
INITIAL SETTINGS (cont.)
Preset Download
Auto Channel Set by Downloading
from TV/Auto Clock Set/Auto Guide
Program Number Set
NOTES:
● For details, refer to the instruction manual of your TV.
● In the area where no TV station transmits a PDC (Programme
Delivery Control) signal, the unit can perform neither Auto
Clock Set nor Auto Guide Program Number Set.
● If there is a power cut, or if you press 1 or SET UP MENU
while downloading or set up is in progress, it will be
interrupted; be sure to turn off the unit power once and try
again from the beginning.
● Auto Clock Set may not function properly depending on the
reception condition.
● On this unit, the characters available for station names (ID) are
A–Z, 0–9, –, f , + and I (space). Some names of downloaded
stations may differ from those of your TV. (
੬
pg. 83)
If you have connected the unit to your TV via the AV connection
(
੬
pg. 15), the unit will automatically perform Preset
Download instead of the Auto Set Up in step B on page 16.
After downloading, the unit sets the clock and Guide Program
numbers automatically.
A
Turn on the unit.
Press 1 on the unit or remote control.
B
Perform Preset Download.
The AUTO SET/T-V LINK display appears on the front
display panel and/or on the TV screen.
On the front display panel
Press
rt to select “CH – –” and press OK or e.
C
Set the video channel.
Set the video channel to off manually. (
੬
pg. 88)
ATTENTION
You can use this function only with a TV offering T-V Link,
etc.* Be sure to use a fully-wired 21-pin SCART cable.
* Compatible with TVs offering T-V Link, EasyLink, Megalogic,
SMARTLINK, Q-Link or DATA LOGIC via fully-wired 21-pin SCART
cable. The degree of compatibility and available functions may
differ by system.
Slide the TV/S-VHS/DVD switch to the right.
On the on-screen display
Press
rt to move the
highlight bar (pointer) to
“T-V LINK” and press OK or
e.
Preset positions on the front display panel increase from
“CH1”; do NOT press any button on the unit or remote
control until the front display panel shows clock time,
“(CH) 1” or “– –:– –” as illustrated on page 19.
● If you are using the on-screen
display, the T-V LINK screen
will appear. Then the GUIDE
PROG SET screen will appear
during Guide Program
Number Set. When Preset
Download is completed,
“COMPLETED” appears for
about 5 seconds, then the
normal screen appears.
● If you press any button on the
unit or remote control while
downloading is in progress, it
will be interrupted.
After “Preset Download” is completed, perform
“Monitor Set (DVD deck)” on page 20.
XVS20EK_06Index.fm Page 18 Tuesday, April 1, 2003 3:39 PM