Make connections, Connecting to a dolby digital decoder or, An amplifier with a built-in dts (dvd deck only) – JVC HR-XVS20EK User Manual
Page 69: Dvd deck only)
Masterpage:Right-No-Heading
69
Filename [XVS20EK_09Editing.fm]
Page 69
March 28, 2003 6:55 pm
Connecting To A Dolby Digital Decoder
or An Amplifier With A Built-in DTS
(DVD deck only)
These instructions enable you to connect your unit to dolby digital decoder or amplifier with a built-in DTS.
Make connections.
Connect the optical cable between the unit and the
Dolby Digital decoder or amplifier with a built-in DTS.
NOTES:
● For Dolby digital sound, set “DIGITAL AUDIO OUTPUT” to
“DOLBY DIGITAL/PCM”. (
● For DTS sound, set “DIGITAL AUDIO OUTPUT” to “STREAM/
PCM”. (
CAUTIONS:
● This unit has a dynamic range of more than 80 dB with regards
to its Hi-Fi audio capability. It is recommended that you check
the maximum level if you are going to listen to the Hi-Fi audio
signals through a stereo amplifier. A sudden surge in the input
level to the speakers may damage them.
● Some speakers and televisions are specially shielded to
prevent television interference. If both are of the non-shielded
type, do not place the speakers adjacent to the TV set as this
can adversely affect the video playback picture.
Back of unit
Note for connection:
Remove the connector cover
from the unit and remove the
protection cap from the
cable.
Optical cable
(not provided)
Dolby Digital decoder or
amplifier with a built-in DTS
DIGITAL AUDIO OUT
To DIGITAL AUDIO
input
XVS20EK_01.book Page 69 Friday, March 28, 2003 7:00 PM