JVC CA-MXDVA9 - Manual (Page 17)

– 14 –
Creating Your Own Sound Modes
—Manual Mode
You can create SEA patterns to suit your preference. These
changed settings can be stored in the MANUAL 1,
MANUAL 2, and MANUAL 3 modes.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
On the unit ONLY:
1
Select one of the preset sound modes.
• If you want to add the surround elements in your
SEA pattern, select one of the sound modes (D.CLUB,
HALL, or STADIUM) before starting the procedure
below. (See “Selecting the Sound Modes” on page 13.)
2
Press and hold SET until “SEA
CONT” appears on the display.
3
Adjust the SEA pattern.
1) Turn
4 / ¢ to select
the frequency range to
adjust (LOW, MID or
HIGH).
2) Press
¡ or 1 to
adjust the level (–3 to +3) of
the selected frequency range.
3) Repeat steps 1) and 2) to
adjust the level of the other
frequency ranges.
4
Press SET again.
5
Turn
4 / ¢ to select one of
the MANUAL 1, MANUAL 2,
and MANUAL 3 modes into
which you want to store the
SEA pattern.
6
Press SET.
The SEA pattern you have created is stored into the
MANUAL mode selected in step 5.
To use your own sound mode
Select MANUAL 1, MANUAL 2, or MANUAL 3 mode. See
“Selecting the Sound Modes” on page 13.
When you unplug the AC power cord or if a power
failure occurs
The setting will be erased in a few days. If this happens, set the
manual sound modes again.
Ex.: When “D.CLUB” is selected as the sound mode.
Current level appears.
EN11-15.CA-MXDVB10,B9,A9_f 02.4.24, 9:42 AM 14