JVC CA-MXDVA9 - Manual (Page 34)

– 31 –
Using DSP Surround Mode
S THEATER L THEATER LIVECLUB
PAVILION CHURCH OFF
(DSP off)
In order to reproduce a more acoustic sound field in your
listening room while playing any source, you can use
following DSP Surround modes.
• DSP Surround mode can be also used for a disc encoded
with Dolby Digital 5.1ch or with MPEG Multichannel.
You can select one of the following DSP Surround modes
according to your preference.
S (Small) THEATER: Reproduces the sound field of a small
theater (where the seating capacity
about 300).
L (Large) THEATER: Reproduces the sound field of a large
theater (where the seating capacity
about 1,000).
LIVECLUB: Gives the feeling of a live music club
with a low ceiling.
PAVILION: Gives the spacious feeling of a
pavilion with a high ceiling.
CHURCH: Gives the spacious feeling of a
majestic church with a high ceiling.
Activating and Adjusting the DSP Surround
Mode
You can use the DSP Surround mode for any source you like.
On the remote control:
Only when using the remote control, you can adjust the delay
time of the surround speakers.
1
Press DSP SURROUND, while holding down
SHIFT, to select a desired DSP Surround
mode.
• Each time you press the button, the DSP Surround mode
changes as follows:
• When one of the DSP Surround modes is activated, the
SURROUND lamp on the unit lights up.
2
Press LEVEL SELECT repeatedly
until “DELAY” appears on the
display.
3
Press LEVEL + / – to adjust the
delay time.
• Each time you press the button, the delay
time changes as follows:
As the number increases, the delay time increases so that
you can obtain much larger sound field.
• This setting does not affect the delay time setting of the
“SPEAKER SETTING.” (See page 40.)
To cancel the DSP Surround mode, select “OFF” in step 1
so that the SURROUND lamp goes off.
On the unit:
When using the buttons on the unit, you can activate the DSP
Surround modes, but cannot make delay time adjustment.
Press DSP SURROUND > or < to
select a desired DSP Surround
mode.
• Each time you press the button, the DSP
Surround mode changes as follows:
• When one of the DSP Surround modes is activated, the
SURROUND lamp on the unit lights up.
To cancel the DSP Surround mode, select “OFF” so that the
SURROUND lamp goes off.
When you use one of sound modes with surround
elements—D.CLUB, HALL, STADIUM (see page 13)
You can set these sound modes together with the DSP Surround
modes, but the surround elements of these sound modes are changed
to the DSP Surround mode.
+
S THEATER L THEATER LIVECLUB
PAVILION CHURCH OFF
(DSP off)
DELAY 1 DELAY 2 DELAY 3
DELAY 4 DELAY 5 DELAY 6
EN28-31.CA-MXDVB10,B9,A9_f 02.4.24, 9:44 AM 31