JVC CA-MXDVA9 - Manual (Page 47)

– 44 –
Using the Timers
There are three timers available—Daily Timer, Recording
Timer, and Sleep Timer.
Before using the timers, you need to set the clock built in the
unit. (See page 11.)
Using Daily Timer
With Daily Timer, you can wake to your favorite music or
radio program. You can set the timer whether the unit is on or
off (on standby).
How Daily Timer actually works
The unit automatically turns on, set the volume level to the
preset level, and starts playing the specified source when the
on-time comes (the
indicator continues flashing while the
timer is operating). Then, when the off-time comes (“OFF”
flashes just before the off-time), the unit automatically turns
off (on standby).
The Daily timer works everyday automatically. If you do not
want to use the Daily timer, turn off the Daily timer. (See “To
turn off or on Daily Timer after its setting is done” on the
next page.) The timer setting remains in memory until you
change it.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
• To correct a misentry while setting the timer, press
CANCEL/DEMO.
Before you start...
• When using a DVD, SVCD or VCD as the source to
play—
–Make sure that a TV is set to turn on at the setting time
and the correct input mode is selected.
–Make sure there is a disc on the selected disc number
tray.
• When using a CD as the source to play—
–Make sure there is a disc on the selected disc number
tray.
• When using a tape as the source to play—
–Make sure that a tape is in the deck whose deck
indicator (A or B) is lit on the display.
–Make sure that the tape direction is correct.
• When using tuner as the source to play—
–Set the preset stations.
• When using the external component as the source to
play—
–Set the timer equipped on the external component at
the same time.
DAILY
Canceled
ON TIME
(Daily timer setting)
ON TIME
(Recording
timer setting)
Clock
setting
(The hour digits
start flashing.)
REC
On the unit ONLY:
1
Press CLOCK/TIMER repeatedly
until “DAILY” appears on the
display.
indicator lights up and DAILY (Daily
Timer) indicator also starts flashing on the
display.
• Each time you press the button, the timer setting modes
change as follows:
2
Press CLOCK/TIMER again.
“ON TIME” appears for 2 seconds on the
display, then the unit enters on-time setting
mode.
3
Set the on-time you want the
unit to turn on at.
1) Turn 4 / ¢ to set the hour, then
press SET.
2) Turn
4 / ¢ to set the minute,
then press SET.
“OFF TIME” appears for 2 seconds
on the display, then the unit enters
off-time setting mode.
4
Set the off-time you want the unit to turn off
(on standby) at.
1) Turn
4 / ¢ to set the hour, then press SET.
2) Turn 4 / ¢ to set the minute, then press SET.
The unit enters source selecting mode.
Continued
EN44-56.CA-MXDVB10,B9,A9_f 02.4.24, 9:46 AM 44