Janome 350E - Manual (Page 10)

8
q
w
e
r
t
y
z
x
c
v
Inserting the bobbin
z Place the Bobbin in the Bobbin Holder with the
thread running off in the counterclockwise
direction.
q Thread
w Bobbin holder
x Guide the thread into front notch on the front of
the bobbin holder.
Draw the thread to the left, sliding it between the
tension spring blades.
e Front notch
c Continue to draw the thread lightly until the
thread slips into side notch.
Pull out about 10 cm (4") of thread to the rear.
r Side notch
v Refer to the threading chart shown on the hook
cover plate.
Reattach the hook cover plate.
t Hook cover plate
y Threading chart