Trace outline – Janome 350E User Manual
Page 29
27
i
i
i
i
i Trace key
You can check the size of the sewing area by pressing
this key. The carriage traces the outline of the selected
embroidery pattern without stitching.
The carriage will return to the starting position after
tracing and the screen will return to the previous
display.
To cancel the outline tracing, press the cancel key.
o Cancel key
!0
!0
!0
!0
!0 Carriage store key
Press the Carriage store key to bring the carriage back
to its stored position after finishing embroidery.
Screen Information
Besides the design image, approximate sewing time in
minutes, number of colors, design size and the hoop
that should be used for the selected design are shown.
!1 Sewing time in minutes
!2 Number of colors
!3 Design size
!4 Hoop
!5
!5
!5
!5
!5 Stitch Back/Forward keys
When embroidery sewing has started, the screen will
indicate the current stitch counts. The Jog keys will
disappear and the Stitch back/forward keys will be
indicated on the screen. You can use these keys to
move the embroidery hoop to where the thread has
broken or run out.
Press the Minus key to move the hoop back to a
previous sewing point. The hoop will move backward
every 10 stitches when you press this key.
Press the Plus key to move the hoop ahead. The
hoop will move forward every 10 stitches when you
press this key.
!6
!6
!6
!6
!6 Jog/ST key
Press this key to switch the Jog keys to the Stitch
back/forward keys before sewing.
NOTE:
Before you turn the power switch OFF, always be sure
to return the carriage to its stored position.
A Z
Mode
Ready to Sew
Jog
ST
Trace outline
Cancel
A Z
Mode
Paused
Jog
ST
o
!1
!2
!4
!5
!5
!5
!5
!5
!6
!6
!6
!6
!6
!3
i
i
i
i
i !0
!0
!0
!0
!0