Janome 350E - Manual (Page 9)

7
q
w
e
w
q
Winding the bobbin
z Guide the thread around the bobbin winder thread
guide while holding the thread at the spool.
q Bobbin winder thread guide
x Thread through the hole in the bobbin from the
inside to the outside. Put the bobbin on the bobbin
winder spindle.
w Bobbin winder spindle
c Push the spindle to the right. Press the Start/Stop
button while holding the end of the thread. Stop
the machine after the bobbin has made a few
turns. Cut the thread close to the hole in the
bobbin.
v Press the Start/Stop button again. When the
bobbin is fully wound it will stop automatically.
Press the Start/Stop button to stop the machine
then return the bobbin winder spindle to the left.
Remove the bobbin and cut the thread with the
bobbin thread cutter.
e Bobbin thread cutter
NOTES:
Do not move the bobbin winder spindle while the
machine is running.
For safety purposes, the motor will stop automatically
after running for two minutes.
z
x
c
v