Janome 350E - Manual (Page 18)

16
Adhesive (Iron-on) Stabilizer
Place the Wrong side of fabric and the glossy side of
the stabilizer together. Fold up a corner of the
stabilizer and fuse it with an iron.
NOTES:
Fold up a corner of the stabilizer, to make it easier
to peel off the excess stabilizer after stitching.
Ironing temperatures vary depending on kind of
adhesive type stabilizer.
StabilizerS
To obtain the best quality embroidery, it is important to
use stabilizers.
Types of stabilizer
Tear-away Stabilizer is made from a fiber that will tear
easily. Use tear-away stabilizers for stable woven
fabrics. After stitching, tear away the stabilizer so that
the small portion left in the back of the stitching will not
affect the wear.
Iron-on Stabilizer is an adhesive type stabilizer for knits
and all kinds of unstable fabrics. Fuse it to the wrong
side of the fabrics with an iron.
Cut-away Stabilizer is a non-woven fabric that does not
tear. Cut the excess portion after stitching. Use
cutaway
stabilizers for knits and all kinds of unstable
fabrics.
Water Soluble Stabilizer will dissolve in water. Use this
stabilizer for cutwork or lace embroidery, and also for
the right side of looped fabrics such as towel to avoid
loops coming through the embroidery.
Sticky Stabilizer is a sticky paper used for securing a
small fabric or work that cannot be secured in the
hoop.
It is also used for velvet and other napped fabric that
would be permanently marked by the hoop.
Usage:
The stabilizer should be attached to the wrong side
of fabric.
More than one layer may be required.
Felt or stable fabrics do not need to be stabilized
and you may embroider directly on it.
For firm fabrics, you may place a thin paper under
the fabric.
The non-adhesive type should be used when
embroidering fabric, which cannot be ironed or for
sections, which are difficult to iron.
Cut the stabilizer larger than the embroidery hoop
and set it on the hoop so that the entire piece is
fastened with the hoop to prevent looseness of the
fabric.