JVC DR-M10 - Manual (Page 34)

Filename [DR-M10U_06-2Initial Set.fm]
Masterpage:Left+
34
EN
Page 34 February 5, 2004 6:56 pm
INITIAL SETTINGS (cont.)
E
Enter the DBS receiver’s brand.
A Press rt to move the arrow to “DBS RECEIVER
BRAND”, then press ENTER.
B Press rt to select the brand code from the following
list, then press ENTER.
C Press rt to move the arrow to “TEST MODE”, then
press ENTER. The program currently received through
the DBS receiver appears.
If the DBS receiver’s channel
changes to the channel listed
below for your brand, setting
is complete.
JVC ] 100
ECHOSTAR ] 100
SONY ] 205
RCA ] 205
Press ENTER and “DBS RECEIVER CONTROL IS ON”
appears on the screen for about 5 seconds, then press
ENTER.The screen in step
C appears.
If the DBS receiver’s channel does not change as shown
above;
A Press w e to move the arrow to “NO”, then press
ENTER.
B Repeat step E.
NOTES:
● The Controller may not work with all types of DBS receiver.
● If your DBS receiver does not respond to the code, you cannot
use the Controller to change satellite channels. In this case,
make sure to leave the DBS receiver turned on and tuned to
the proper channel before the scheduled start time of timer
recording.
● The unit can only change the satellite channel through the
Controller during timer recording.
● If your DBS receiver cannot be operated with a Remote
(because it has no remote sensor), you cannot use the
Controller to change its channels. Make sure to leave the DBS
receiver turned on and tuned to the proper channel before the
scheduled start time of timer recording.
● If the unit’s memory backup expires because of a power
failure, set the cable box output channel and brand again.
● For customers in U.S.A.: If you are unable to set the
Controller, contact JVC toll free at 1-800-252-5722.
BRAND NAME CODE
JVC (DISH Network)
ECHOSTAR (DISH Network)
SONY (DSS)
RCA (DSS) 51
51
41
40
DR-M10U_06-2Initial Set.fm Page 34 Thursday, February 5, 2004 6:56 PM