JVC DR-M10 - Manual (Page 65)

Masterpage:Right-No-Heading
EN
65
Filename [DR-M10U_08Recording.fm]
Page 65 January 26, 2004 10:56 am
F
Enter the recording stop time.
Press w e to select “STOP”, then press rt repeatedly to
set the desired stop time.
● Each press of rt advances/goes back the stop time in 1-min.
increments.
● To advance/go back the stop time in 30-min. increments, press
and hold rt.
G
Enter the channel position.
Press w e to select “CH”, then press rt repeatedly to
select the desired channel.
● If you are using a DBS receiver, see “ATTENTION FOR DBS
RECEIVER USERS” in the right column.
H
Set the other recording options as required.
Refer to step E in “VCR Plus+ ® Timer Programing”
(
੬
pg. 60).
I
Access the confirmation screen.
Press ENTER.
J
Complete timer programing.
Press ENTER.
● To program another timer, repeat steps B – J.
K
Engage the unit’s timer mode.
Press # (TIMER). The unit turns off automatically and
“#” appears on the front display panel.
● To disengage the timer mode, press # (TIMER) again.
NOTES:
● When two successive programs are recorded on a DVD-RW
disc with Manual timer programing recording function, the
beginning of the second one may be left off the recording.
● If the copy limited program is received during timer-recording,
the unit enters Record Pause mode. Recording starts again if it
is switched to a recordable broadcast during the time you
programed.
Cable Box or DBS Receiver Users
To timer-record a satellite broadcast using Manual Timer
Programing:
A Perform “Cable Box Control Setting” (
੬
pg. 29) or “DBS
Receiver Control Setting” (
੬
pg. 32).
B Perform “Manual Timer Programing”.
C Leave the Cable Box or DBS receiver’s power on.
ATTENTION FOR DBS RECEIVER USERS
If you are using a DBS receiver (unless “DBS RECEIVER SET”
is set to “OFF”
੬
pg. 33), the band indication (TV, CATV or
DBS) appears on the left of the channel number indication.
No indication:
To timer-record a regular TV broadcast received on
the unit.
CATV: To timer-record a cable TV broadcast received on the
unit, or through a cable box (unless “CABLE BOX
SET” is set to “OFF”
੬
pg. 30).
DBS: To timer-record a satellite broadcast received through
a DBS receiver.
NOTE:
If the channel number entered requires that the band be set,
“7=DBS” is displayed on the screen.
If this happens, press the DBS (number key “7”) to select
“DBS”.
DR-M10U_08Recording.fm Page 65 Monday, January 26, 2004 10:57 AM