JVC DR-M10 - Manual (Page 97)

Masterpage:Right-No-Heading
EN
97
Filename [DR-M10U_11Subsidiary.fm]
Page 97 January 16, 2004 7:25 pm
AUDIO OUTPUT
(The boldface settings in the table below indicate the settings at your purchase.)
8 DIGITAL AUDIO OUT
DOLBY DIGITAL/PCM
STREAM/PCM
PCM ONLY
Set to the appropriate mode according to the type of the device connected to
DIGITAL OUT connector.
DOLBY DIGITAL/PCM :
Select this when you connect the digital input connector of a Dolby
Digital decoder or an amplifier with a built-in Dolby Digital
decoder.
STREAM/PCM :
Select this when you connect the digital input connector of an
amplifier with a built-in DTS, Dolby Digital, or MPEG multichannel
decoder.
PCM ONLY :
Select this when you connect the linear PCM digital input of other
audio equipment (amplifier, MD or DAT deck, etc.).
8 ANALOG AUDIO OUT
STEREO
DOLBY SURROUND
Select the appropriate setting to accommodate the unit to the connected A/V
equipment. This function takes effect when a DVD VIDEO disc is played back.
STEREO :
Select this when listening to conventional two-channel stereo audio
with the unit’s AUDIO OUTPUT connectors connected to a stereo
amplifier/receiver or TV set, or in case you want to record the audio
from a DVD VIDEO disc to a Mini Disc, etc.
DOLBY SURROUND :
Select this when listening to multichannel surround audio with the
unit’s AUDIO OUTPUT connectors connected to an amplifier/
receiver with a built-in surround decoder or a surround decoder.
8 D. RANGE CONTROL
NORMAL
WIDE RANGE
TV MODE
The dynamic range (the difference between the loudest sound and the quietest
one) can be compressed during playback of a program encoded in Dolby
Digital format.
This function takes effect when a DVD VIDEO disc recorded in Dolby Digital
format is played back at low or middle volume.
NORMAL :
Normally select this setting to activate this function.
WIDE RANGE :
Select this to deactivate this function when you enjoy wide dynamic
range program.
TV MODE :
Select this when you hear the sound through the TV’s speaker(s).
NOTES:
● This function takes no effect on programs other than that recorded in Dolby Digital
format.
● This function dose not work when Simulated Surround Effect is activated. ( ੬
pg. 50)
● The effect of “NORMAL” and “WIDE RANGE” may not be different depending on discs.
8 OUTPUT LEVEL
STANDARD
LOW
You can lower the output level of analog audio to accommodate the unit to the
connected A/V equipment.
STANDARD :
Normally select this setting.
LOW :
The output level of analog audio is lowered.
DR-M10U_01.book Page 97 Friday, January 16, 2004 7:38 PM