JVC DR-M10 - Manual (Page 91)

Masterpage:Right0
EN
91
Filename [DR-M10U_10Editing.fm]
Page 91 March 4, 2004 5:22 pm
REMOTE
Remote Control
Functions
Remote 1/2/3/4 Code Switching
The Remote is capable of controlling four JVC video units
independently. Each of the units can respond to one of four
codes (1, 2, 3 or 4). The Remote is preset to send 3 code signals
because your unit is initially set to respond to 3 code signals.
You can easily modify your unit to respond to 1, 2 or 4 code
signals.
On the Remote
Keep pressing SET UP down during steps A – B.
A
Change the remote control code.
Press the number key “1” for 1, “2” for 2, “3” for 3 or
“4” for 4.
B
Set the remote control code.
Press ENTER to set the code.
On the unit
C
Turn off the unit.
Press 1 on the unit.
D
Display the code.
Press 4 on the unit for over 5 seconds while the unit is
turned off.
● The code currently set appears on the front display panel.
E
Change the unit’s code.
Press 8 on the Remote.
● The code currently set on the Remote blinks on the front
display panel for approximately 5 seconds, and is applied to
the unit.
NOTE:
When “POWER SAVE” is set to “ON” (
੬
pg. 99), it is not
possible to change the remote code.
Slide the TV/CABLE/DBS/DVD switch to DVD.
CABLE/DBS
DVD TV
DVD
CH
TIMER REC LINK PROG/CHECK VCR Plus+
NEXT PREVIOUS
PAUSE REC
REC MODE LIVE CHECK
SET UP DISPLAY ON SCREEN
OPEN/
CLOSE
AUDIO SUBTITLE ANGLE
PROGRESSIVE
SCAN
SLOW SLOW PLAY/SELECT
STOP/ CLEAR
NAVIGATION TOP MENU
RETURN
ENTER
MENU
TV/CBL/DBS
STANDBY/ON TV
MUTING
TV/
VIDEO
TV VOLUME ABC
JKL GHI MNO
TUV PQRS WXYZ
AUX CANCEL MEMO/MARK
DBS
DEF
ENTER
8
SET UP
1 – 4
1 STANDBY/ON
S-VIDEO VIDEO L(MONO)-AUDIO-R
DV DV IN F1
REC MODE
PULL - OPEN
1
4
DR-M10U_10Editing.fm Page 91 Thursday, March 4, 2004 5:22 PM